One Truck, Two Trucks, Yellow Trucks & More – Solving a Mystery at the Airport

June 29, 2021
And, finally, here are new old photos showing both CB3000 crash trucks at the CFR station at the same time. Proof positive of what’s explained below. Sid Meier photos, scanned from film prints.

Sid Meier photos

May 11, 2016
Let’s solve a mystery.

Did the airport fire department have one or two Walters CB3000 crash trucks, back in the day? Wait, doesn’t story go that the 1973 Walter CB3000 (delivered new) was re-manufactured by Crash Rescue Equipment Services in/around 1990? Yes, that’s the long-told story.

Then a certain fire historian heard an interesting story the other day. He’s resumed his research on RDU CFR history, and an old-timer told him, “I seem to remember that one of those rehabbed Walters was from a different department. It was a replacement that was already built, and not one of ours.”

Wait a minute, what?

Early ARFF Rigs

First, let’s review the details of the airport’s ARFF rigs, from the 1970s to the 1990s. After the delivery in 1969 of an International/Ansul dry-chemical/light water rig, the airport obtained an ex-Army 1959 Walter Class 1500 crash truck. This met their need for “big water/big foam” until the purchase of a new 1973 Walter CB3000. Four years later, a second crash truck was purchased, a new 1977 Walter B1500. And after which, the 1959 Walter was presumably disposed, and later parked as a permanent exhibit at the Durham Museum of Life and Science.


Photo credit: (Raleigh) News & Observer and Dale Johnson (lower right)

Three crash trucks, plus an earlier ex-Army 1946 International/Bean Class 125 pumper (below left) that was replaced in 1979 by a Chevrolet/Reading utility body truck with a skid-mounted dry chemical system. (Said skid system was previously mounted on a pick-up truck. There was also a second skid system, mounted on a pick-up truck and later a trailer.)


Photo credit: (Raleigh) News & Observer (left) and RDU CFR (right).

Entering The Eighties

And with those four rigs (CT1 through CT4), the airport entered the eighties with a quartet of new or somewhat new apparatus:

  • CT1 – 1979 Chevrolet/Reading
  • CT2 – 1969 International/Ansul
  • CT3 – 1977 Walter
  • CT4 – 1973 Walter

By the end of the decade, however, an upgrade was in order. Three “big water/big foam” trucks were needed, instead of two. And improvements were sought for the two 1970s Walter crash trucks.1

In October 1989, a third crash truck was delivered, a rebuild of a 1970s Walter B1500 by Crash Rescue Equipment Service (CRES). As old-timers tell it, the rig was identical to their 1977 Walter B1500. And the original B1500 was subsequently sent to CRES, for it’s own rebuild. The 1977 truck was rehabbed from top to bottom and with improvements ranging from new turrets to added air conditioning.

1Why the need for a third water/foam truck in 1989? Probably the result of the new runway in 1986, and the larger aircraft later using the 10,000-foot strip. Also, the 1969, 1973, and 1977 crash trucks were getting older, with more likelihood of a truck being out of service. And without another unit of equivalent capacity, they’d be in trouble.

Rehabbed or Replaced?

As for the 1973 Walter, the original story said that it was also rebuilt by CRES. That’s what folks remembered and historians (including myself) have recorded. But then we (meaning me) noticed these pictures.


Photo credit: Lee Wilson

The 1973 Walter is designated as CFR 14. And that didn’t make sense. The 1969 International/Ansul was designated CFR 12, but only after it’s replacement was delivered in 1989. The Ansul was originally CFR 2, and changed to CFR 12 after the delivery of the 1989 CRES/197_ Walter B1500.

And if the “12” designation referred to a “displaced rig,” wouldn’t the same logic apply to a “14” designation? Curiouser and Curiouser.

Next, Mr. Historian (you know him as Mr. Blogger) carefully compared photos of the 1973 Walter as CFR 14 with the subsequent CRES rehabbed version. Practically identical! Sure appeared to be before and after pictures.


Photo credit: Lee Wilson (left) and Pete Brock (right)

Then came the a-ha moment. Look at the photo on the left. Notice the door of the rig behind CFR 14. Slanted stripe. Now look at this group photo of the airport’s three CRES rigs. Two of them have straight stripes. Only one has a slanted stripe. The rehabbed CB3000.

Click to enlarge:


Photo credit: Lee Wilson

Thus the likely interpretation–and really that’s all historians are able to do, which is interpret history–is that the 1973 Walter CB3000 never left the airfield, and a second CRES-rebuilt Walter CB3000 was delivered circa 1990.

This interpretation is further reinforced by a log book entry in November 1990. It reads “foam nozzle cleaned on CFR 4” and “hose repacked on CFR 14.” Ergo, both rigs on site at the same time:

With signs pointing to yes, Legeros contacted a former fire chief at the airport. He confirmed the conclusions drawn above. He also noted that CFR 4 (1989 CRES/197_ Walter) and CFR 14 (1973 Walter) were operated in tandem while the 1977 Walter was being rehabbed by CRES. Once the returned, CFR 14 was disposed to CRES. e.g., a trade-in.

But Still a Few Questions

Mystery solved? Mostly.

Still don’t know the model years for the rehabbed Walter CB3000 in 1990. For now, calling it a 1990 CRES/197_ Walter. The truck had diesel engines, instead of gasoline. Presuming identical capacity to the 1973 version, which was 1500 GPM, 3000 gallons of water, 500 gallons of foam.

Also don’t know the model year of the first rehabbed Walter B1500. We’ll cite as 1989 CRES/197_ Walter. Presuming identical capacity to the 1977 version, which was also rehabbed by CRES. That was 1000 GPM, 1500 gallons of water, 180 gallons of foam.

Thoroughly confused? Here’s the scorecard:

  • 1969 International/Ansul dry chemical/light water rig. Delivered new. Designated CFR 2 until 1989, then CFR 12.
  • 1959 Walter Class 1500 crash truck. Obtained used circa 1970. Designated CFR 3 until 1977, then disposed.
  • 1973 Walter CB 3000 crash truck. Delivered new. Designated CFR 4 until circa 1990, then CFR 14.
  • 1977 Walter B1500 crash truck. Delivered new. Designated CFR 3. Then rehabbed by CRES circa 1990.
  • 1989 CRES/197_ Walter B1500 crash truck. Delivered “new”. Designated CFR 2.
  • 1990 CRES/197_ Walter CB3000 crash truck. Delivered “new”. Designated CFR 4.

Got it?

See this apparatus history page for the complete list and details.

Now, How About a Second Mystery?

Where did the two CRES built crash trucks originally serve? Good question. To be determined. The 1989 CRES/197_ Walter CB3000 was apparently wrecked when new, at its original airport. The incident also involved a fatality. When and where? To be determined. Was the truck first repaired by Walter, and later re-rebuilt by CRES? To be determined.

One more mystery to solve!

And a Visit to CRES

Our friends at the airport fire department also shared these pictures of a visit to CRES in December 1988. The plant is located in Dallas, TX.

Talk about an ARFF-a-palooza! Click to enlarge:




Photo credit: RDU CFR

Sources

Notable sources for this blog posting:

  • Fire Apparatus Journal, Volume 19, Number 5, “On the Runway” by Mark A. Redman and Pete Brock, September-October, 2002.
  • Raleigh-Durham Airport Fire-Rescue log books, photographs.
  • Raleigh-Durham Airport Fire-Rescue History by Mike Legeros, http://www.legeros.com/ralwake/rdu.
  • Oral Histories.
Facebook Comments

Leave a Reply

Your email address will not be published. Required fields are marked *